.....the system designer/installers' source for innovative products designed to keep audio/video equipment and home theater installations cool....... quietly!
A cooler for use with amps, receivers, surround-sound decoders or any other equipment that runs hotter than it should. Just center it over the heatsinks and plug the wall-type power supply into a switched outlet on your receiver or preamp. The Cool-it will send a quiet stream of room temperature air down the heat sink fins to the power transistors in the amp or receiver, ensuring that they operate many degrees cooler than they would normally.
Ideal for amps and receivers which must operate with limited ventilation, such as inside partial enclosures.
Cool-its can be used in pairs - a single unit is shown above for clarity. Each module covers an area approximately 15" by 7"; they may be interconnected, and are placed over the hottest part of the product to be cooled.
A special version is now available on special order to cool equipment with solid top panels
Optional modules are available to provide 12 volt trigger or thermostatic control and can be added at any time.
Specifications: Dimensions: 15" l x 6 3/4" d x 2 1/8" h
Remember ----"It isn't cool to run hot"
Factory Technical Support Information 661-294-7999 (8:00 AM to 6:00 PM PST)
Factory address 4114 Aliso Street,
Acton, CA 93510
Electronic mail General Information: firstname.lastname@example.org
over the phone or by E-mail.
ORDERING BY PHONE
If there is no authorized dealer in your area you can order directly from Soundscape with a 10-day, satisfaction, money-back guarantee.
Monday - Friday 12:00 AM - 5:00 PM (PST)
Last Update: November 1, 2016
Audio & Video
8499 Old Redwood Dr.#206, Windsor, CA 95492
Phone 707- 578-4434